Mizar Moissanite Tester Terminator II - MT 2

$129.95

Moissanite Tester Terminator II - MT2

 

Mizar Moissanite Tester Terminator II - MT 2

Ease of use make this the most popular moissanite tester. No power pack or spring clips needed, it works off a 9V battery. The Moissanite Terminator II has dual test voltages to insure 100% accuracy.

Mizar Moissanite Tester Terminator II - MT 2 Grafic

1. PROBE AND PROBE COVER
2. MOISSANITE INDICATOR
3. ADJUSTMENT KNOB
4. TESTING/ BATTERY OK INDICATOR
5. BATTERY COMPARTMENT/ COVER
6. TEST BUTTON

MT2 MOISSANITE TERMINATOR IS USED TO IDENTITY ARTIFICIAL MOISSANITE GEM STONES AND OTHER MAN MADE SYNTHETIC GEM STONES. NO OTHER INSTRUMENT OR TESTER IS REQUIRED TO IDENTIFY MOISSANITE GEM STONES.

 

MOISSANITE TESTING INSTRUCTIONS
1. SET THE ADJUSTMENT KNOB TO THE RIGHT (LARGE STONE SETTING) #3.
2. REMOVE PROTECTIVE END CAP, #1.
3. WITH YOUR THUMB PRESS THE PRESS AND HOLD BUTTON, #6 WHILE YOUR FINGERS TOUCH THE REAR METAL PLATE.
4. THE YELLOW TESTING LIGHT #4 SHOULD LIGHT AND MUST STAY ON DURING ALL TESTING.
5. WITH YOUR OTHER HAND HOLD THE METAL PART OF THE RING OR ANY SOLID METAL PART CONTAINING THE GEM STONE. WHEN USING THE LOOSE STONE HOLDER YOUR OTHER HAND MUST HOLD THE LOOSE STONE HOLDER.
6. PLACE THE TESTER PROBE IN THE CENTER OF THE GEM STONE TO BE TESTED WITHOUT TOUCHING THE TESTER PROBE TO ANY METAL SURFACE. DO THIS IN A MANOR THAT THE METAL PART OF THE TESTING PROBE IS AS FAR AWAY AS POSSIBLE FROM ANY METAL FINDINGS OR GEM HOLDING DEVICE. BECAUSE MOISSANITE GEM STONES ARE INCONSISTENT, FOR BEST RESULTS BE SURE TO TOUCH 3 OR 4 POINTS AROUND THE CENTER OF THE GEM STONE.
7. IF A MOISSANITE GEM STONE IS BEING TESTED YOU WILL HEAR A DISCONTINUOUS BEEP AND SEE A FLASHING GREEN LIGHT, #2
8. REAL GEMSTONES WILL NOT INDICATE WHEN USING THE MT2 TESTER. IN ORDER TO IDENTIFY NATURAL DIAMONDS A THERMAL DIAMOND TESTER SUCH AS THE R S MIZAR "PRESTIGE SERIES II" MUST BE USED
9. USE THE SMALL STONE SETTING ONLY WHEN TESTING SMALL STONES, APPROXIMATELY 3.5 MM OR SMALLER, OR WHEN YOU CANNOT KEEP THE PROBE A TENTH OF AN INCH FROM THE METAL PRONGS OR SURFACE.

NOTE: TO TEST UNMOUNTED STONE PLACE STONE IN LOOSE STONE HOLDER. ALWAYS HOLD THE LOOSE STONE HOLDER WITH YOUR FREE HAND.

HELPFUL HINTS

· ALWAYS MAKE SURE THAT THE GEM STONE TO BE TESTED IS DRY AND CLEAN.
· THE ONLY ERROR WHICH CAN BE MADE IS GETTING TO CLOSE TO THE METAL SURFACE. WHEN THIS HAPPENS A SMALL BLUE GLOW CAN USUALLY BE OBSERVED FROM THE PROBE TO THE METAL. IF THIS HAPPENS A MOISSANITE INDICATION WILL BE SEEN & HEARD. KEEP THE PROBE AWAY FROM THE METAL SURFACES.
· IT IS BEST TO TEST IN A CIRCULAR MOTION AROUND THE CENTER OF THE GEMSTONE. SEVERAL POINTS ON THE STONE SHOULD ALWAYS BE CHECKED.
· THE YELLOW TESTING LIGHT MUST REMAIN ON DURING ALL TESTING. IF IT DOESN'T THE BATTERY NEEDS REPLACING. A 9 VOLT TYPE NEDA SIZE 1604 (006P)
· TO IDENTIFY MOISSANITE GEM STONES AND OTHER MAN MADE SIMULANTS ONLY THE "MT-2" TESTER IS REQUIRED
· NO INDICATION WILL BE SEEN OR HEARD WHEN USING THE "MT-2" TESTER ON ANY NATURAL GEM STONES.
· A FUNCTION TEST CAN BE DONE BY SIMPLY TOUCHING YOUR FREE HAND TO THE TESTER PROBE. MOISSANITE WILL BE INDICATED.

WARRANTY
O.N.E. PROVIDES THAT EACH MOISSANITE TESTER WILL BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF TWO YEAR FROM THE DATE OF PURCHASE (BATTERY NOT INCLUDE IN WARRANTY). THIS WARRANTY WILL BECOME VOID BY:
· UNAUTHORIZED REPAIR, MISUSED, MODIFICATION, OR ALTERATION,
· ACCIDENTAL DAMAGE, NEGLECT OR IMPROPER USE.


 Sold Out 
  • Model: Mizar Moissanite Tester Terminat
  • Shipping Weight: 1lbs
  • 0 Units in Stock
  • Manufactured by: Mizar

This product was added to our catalog on Thursday 01 September, 2011.

Copyright © 2017 OK Pocket Scale.com. Powered by Zen Cart